Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kapil
this depends on the application type where you are using
this circuit breaker. actually we will have to know whether
we require some delay in tripping after the overcurrent or a
frequent operation is needed. if a delay is needed and we
will have to bear some over temperature conditions then we
use thermal relay which has some delay and low trip current
at high temp. when we require the frequent operation then we
use magnetic type relay. also we will have to mind the
operating environment, nominal current rating and max peak
current bearing capacity and delay time of the circuit breaker.
| Is This Answer Correct ? | 71 Yes | 25 No |
Post New Answer View All Answers
what is th basic difference between a d latch time line and a d flip flop time line???
how to select automotive wire by mathematical equation with given current, vlotage and resistance
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
what is earthing.how we make it,describe briefly.
What do you mean by ratio correction factor of instrument transformer?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
why we used dc supply for field in dg set
do we use neutral grounding for resistive balanced load? if we use what happen?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
what r the checklist while installing a 380 kva DG set
