Interested to Buy Any Domain ? << Click Here >> for more details...
In any Industry, Which voltage level either 3.3kV or 6.6KV
to be chosen? Then I would like to know ,Is there any cost
consideration or Rating of motor?
- 5 Answers
- 11288 Views
- I also Faced
- E-Mail Answers
Answer Posted / rocks
6.6kv line.it also depend on the rating ot the motor that
is if high motor rating the vtg drop is siginifently more
than low motor rating.hence 606kv line is morepreffered in
industry
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What is sink and source?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
How to run a three phase motor into single phase........
low frequency protection why recomend?
can someone explain that how the speed of the protection system affects the fault level calculation?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
Explain how you intend to work under pressure to meet up with deadline target?
Earth bits close or open. Which is correct
previous year paper of ntpc bhel for degree in electrical enng
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
how much cable size required for 70 kilowatt load.
what is smartµ grid technology?under coal gassification?
How to decide cable tray size?
