WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
Answer Posted / stanly.d'cunha
PLC is Progamable Logic Controller & DCS is Distributed
control system. In brief PLC using for perticular mechine or
production unit. DCS usinging for monitoring & controlling
of entire plant, including PLC.
Is This Answer Correct ? | 546 Yes | 77 No |
Post New Answer View All Answers
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Identification of ss fittings, pilot valves, relief valve.
applications of plc in printing and packaging?
How ejector(or)evactor air pump is working in thermal power plant?
Why plc require in analog input 4-20amp & 0-10 volt?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
How it the difference between force balance system and dispalacement balance system?
how do calibrate the valves.. with clear manual
State some of balance principle’ advantages?
what is gas metering system? gas chromatograph? and gas compressors?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
Question on maha cement
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
how to calibrate steam control valve in steam turbine