Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sewagudde
the automatic voltage regulator (AVR) senses changes in
voltage and sends a signal to the controller on the tap
changer to either raise or lower the tap.it should be noted
that the tap changer is always located on the HV side of
the transformer inorder to interrupt smaller currents as
compared to the LV side
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
where is core-type and shell-type construction suitable for transformers ?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
132/66kv sub-station procation ?
What is power in wattage of 8.5 TR AC
how many electricity poles are there and what are the names and their sizes.
what is mind in cable
how does high earth to neutral voltage affect electronic equipment?
What is difference between Harmonic and Non harmonic Capacitor Bank?
What is Tachometer used to measure?
Define unilateral circuit?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
Why is back emf used for a DC motor? Highlight its significance.
