Interested to Buy Any Domain ? << Click Here >> for more details...
why the generating voltage in India is 11kV or why is it be
transmitted as multiples of 11
- 34 Answers
- 125040 Views
- ACC, Bhel, ECI Engineering and Construction, NTPC, SBL, Senthur Power Services, I also Faced
- E-Mail Answers
Answer Posted / zahid noor
It is only form factor which has a constant of K= 1.11, &
if I can recall the old formula which says Induced
EMF/Voltage in a Transformer was 4.44 phixBxNxA volts,&
hence the voltage ranges for transmission are in the
multiples of 1.11. Regarding other answers of Insulators,
there is no point regarding this & power is being
transmitted through cables also where you need not require
insulators.
| Is This Answer Correct ? | 47 Yes | 25 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
during installation time of transformer and alternator which points we have to observed?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
How test for Ddo vector group test condition?
WHAT IS THE USE OF PIG TAIL IN WINDOW CT ?
harmonics filter
how we arrange the hv side with delta connection in case 33/11kv of transformer.
What are the causes for the failures of sandwich type (Al) busducts?
What do you mean by dependent and independent voltage sources?
What is the difference between a fuse and a breaker?
what is the pre charge circuit,what will be work which function it will be use plz tell me
How seriving & testing of the HT & LT breakers are done. What are the standard Ir values on which we can come to know the test is passed or failed?
what is the difference between interconnection and intraconnections in the circuit diagrams
how you configure motorvision relay (L&T make)from DCS
