Answer Posted / kamal jeet

programming logic control & digital logic control

what is the input of digital counter during the the calibration time?

2376

---

how to calculate range of level transmitter?

2387

---

How process line mpm calculation is done?

1472

---

what are the use of belew gear in general ??

2056

---

Any body have know try work calculation ???

1476

---

what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail

2367

---

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

2137

---

What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch

2264

---

full process of gas turbin?

2155

---

where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve

1827

---

There are many type of control cable like pair,core,tried, What are defination each one

2205

---

Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?

1941

---

i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......

2117

---

what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????

5115

---

How will you test a transistor with a multimeter?

1145

---