Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aditya sharma
plz send me hpcl aptitude paper and hpcl technical aptitude
papers.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What are different types of orifice plates?
steps for installing orifice plate?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
What is the purpose of bypass valve across AS valve.
What are the application of bernoulli’s theorem?
What is intrinsically safe system?
What is the use of control cable?
What is the main difference between Cavitation and Flashing?
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
Tell about your IFFCO plant visit.
Square root calculation for dp flow transmitter?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how do calibrate the valves.. with clear manual
