Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramanathan
A loop is which has a feed back of output&where the error
deduction has been done.eg. in a closed loop there will be
sensing of value & controller will do the job.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
i want to find out iffco get test paper
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
What is difference between differential pressure & delta pressure?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Why plc require in analog input 4-20amp & 0-10 volt?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
How to work togather like sov,limit switch,proxy switch and booster in xv
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
How to calibrate Toxic gas detector?
What is the difference between modbus,fieldbus & profibus
flow transmitter formula?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
What is the reason PT speed not incresed in gas turbine?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
