Interested to Buy Any Domain ? << Click Here >> for more details...
What is the cause of major loss in efficiency of an IC
engine?
- 28 Answers
- 46202 Views
- DRDO, TATA, I also Faced
- E-Mail Answers
Answer Posted / banke
convective heat loss to cylinder wall and improper fuel-air
ratio
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
what is diameter of a suction pipe?
please sent last five years junior engineer mechnical question pappers
Name the gauges?
Explain the cycle of refrigeration system.
Do you receive good benefits as an engineer job?
What is the average salary rate in mechanical engineering job?
i m a 1st year student my senior asks me 2 give intro wht will a impressive answer
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
how to calculate cooling water require to condense x amount of vapor in a condenser.
What parameters to be reported when we send lubricating oil for shore analysis?
"How to check the diode, fuse and bearer switch?"
Did elevation affect weight?
What is the normal vacuum pressure in a steam turbine atmospheric condenser?
increase in unit speed increases the discharge of impulse turbine how?
What does afbc stand for?
