In a parallel circuit dc circuit with two resistors, if you
know the voltage, amperage, and one resistors ohms, what
formula is used to find the second resistors ohms?
Answer Posted / shobana
Current Division Technique.
We know that Voltage in parrall will be same. Only current
will divide. As we know V, I(total), R1 we can use the
following formula:
I1 = (R2/R1+R2)* I(Total)
I2 = (R1/R1+R2)* I(Total)
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
In EB metering we face problem kva jump even in no load condition.can any one help to control this
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
What are the causes for the failures of sandwich type (Al) busducts?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
can u give me a brief idea about power line carrier communication ??
how to calculte capacitor range for single phase induction motors??pls tel
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
how the works electronic energy meter?
How do you determine the size of transformer radiators in a transformer?
why the projects getting loss?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
why connecting surge unit in contactor coil
What does quality factor depend on in resonance?