Answer Posted / Ajay Kumar
Droop control is a method used in power system stabilizers (PSS) for regulating the speed of synchronous generators. It works by adjusting the set point of the generator's excitation system in response to changes in the grid frequency. The set point decreases as the grid frequency increases, and vice versa. This helps maintain stable operation of the power system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
why lightning arrestor are made in two stack of insulator but why not cvt
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
please send me previose rrb junior engineer qustion papers
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
please give some hindalco placement papers for written exam
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
please send me previous year questions of jspl through which i could prepare myself for the test.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
why and how voltage sharing in transformer, during magnetic balance test ?
