Interested to Buy Any Domain ? << Click Here >> for more details...
In Transmission System if the potential difference at the
two end of line are same then is the transmission of power
will continue ? if yes then how.
- 1 Answers
- 2444 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / ram
Yes , because of Power flow of depend on phase difference not voltage difference
Real power depend on phase difference and reactive power depend on voltage difference
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
What do you mean by an instrument transformer?
operation of diesel generator
What is the formulae of Megger value for a A.C.Motor
What happens if i apply 500V to 440V rotary Switch ?
What is the power factor of an alternator at no load?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
Explain how to determine capacitor tolerance codes?
How we can calculate the life of Lead acid battery
