Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sourav
It is important to note that our bearing measurements are all done in the following order: Inside diameter (ID) x Outside diameter (OD) x Width (W).
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between afbc, bfbc, pfbc and pcfb in regard to fluidised bed technologies.
Will a steel cable become longer if it is heated while under load? Explain
What is meant by effectiveness?
Name the gauges?
Explain in an orderly manner how the force in the member of a truss be detected using the method of joint.
what are the application or secification (temp/presure)for which IBR pipes should be used?
What is the meaning of less pumping in AC
dear sir pls send me rrb jr.engineer previous question papper to this email id:snap272@gmail.com
What do you treat in high alkalinity of boiler water?
what is the magnetic (electric) center)
Explain the advantages of cycloidal and involute gears?
what is your expectation
What are the causes of failure of superheater tubes ?
Is there any metal that does not contain iron?
What is the purpose of stern tube?
