Answer Posted / anand yadav

Reverse power protection is used to avoid the generator running as motor, if the prime mover speed drops then generator will become a motor, it will load the other power source and will affect the power factor a lot.

Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?

1970

---

how to calculation increase capacitor,increase power factor for three phase.

2179

---

If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?

2592

---

What is current & voltage ? Voltage perform at any load without current or not?

1883

---

The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition

1901

---

what is the use of vcb & isolator in substation?

2378

---

if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??

1856

---

Why are the laminations insulated from each other?

1161

---

How many kinds of E.L.C.B and how to work E.L.C.B

2040

---

What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?

2147

---

I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2

2924

---

What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?

2219

---

if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current

1717

---

how can tell us the AC indoor or outdoor which Tr and formulls

1765

---

How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?

1986

---