Interested to Buy Any Domain ? << Click Here >> for more details...
under which condition we shall prefer a shunt capacitor
filter?
- 1 Answers
- 4079 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / jack
The power required to run all the electrical appliances is the load as useful power is active power. The active power is expressed in kW or MW. The maximum load connected to the electrical power system is mainly inductive in nature such as electrical transformer, induction motors, synchronous motor, electric furnaces, fluorescent lighting are all inductive in nature.
In addition to these, inductance of different lines also contributes inductance to the system.
Because of these inductances, the system current lags behind system voltage. As the lagging angle between voltage and current increases, the power factor of the system decreases. As the electrical power factor decreases, for same active power demand the system draws more current from source. More current causes, more line losses.
Poor electrical power factor causes poor voltage regulation. So to avoid these difficulties, the electrical power factor of the system to be improved. As a capacitor causes current to lead the voltage, capacitive reactance can be used to cancel the inductive reactance of the system.
The capacitor reactance can be used to cancel the inductive reactance of the system.
Source: https://www.electrical4u.com/shunt-capacitor-capacitor-bank/
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Write down the expression for the average output voltage for step down and step up chopper?
what is work of eoca card in nokia flexi EDGE BTS?
Calculator battery power goes down to 1V from 1.6V in 15 days... What could be the reason?
What is a weighted code?
What is the function of freewheeling diodes in controlled rectifier?
what is the maximum delay gnerated by 555timer and why?
Define what is the conductivity of perfect dielectric?
draw a ckt diagram i/p 230v & o/p 80v??????
What is the use of ranging?
What is meant by linearity?
what are the components has to be done in fpga board (altera)?
Define power electronics?
Explain the construction and application of a jfet.
What is the basis for classifying a material as a conductor, semiconductor, or a dielectric?
What is meant by natural commutation?
