Interested to Buy Any Domain ? << Click Here >> for more details...
For 160kw motor what size of cable and material is needed.?
- 1 Answers
- 2721 Views
- I also Faced
- E-Mail Answers
Answer Posted / dayasagar
for star delta starter the thump rule is cable sizing to be 2 X motor KW ie 160 kw motor require 160 sq mm since 160 sq mm is standard size it is better to go for 185 sq mm this rule applies for all star delta motors. here you can go for higher size
for DOL or VFD driven motors 2 time the KW ie 320 sq mm is required since 320 sqmm is not standard size it is better to go for 300 sq mm here you can go at lower size
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
how to select the double earth conductor if 21A full load?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
When MICC cables used ?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
What are the essential characteristics of signal flow graphs?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
how give earthing conection to household equipment?
How does a digital electronic meter work??????
How to select a contactor? How many types of contactors are available
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
