Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nisha
Amf panel= automatic mains failure panel .
in this panel 2 i/p , like 1) generator and 2) mains .
suppose mains supply fail to supply load at that time DG start .
in amf panel automatic transfer switch are used to transfer power when main fail .its sense by ats controller , controller give the command ats switch and switch transfer at DG SIDE.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Differnce between negative Pahse SequenceFunction and unbalance Function?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
Differentiate between ideal and non-ideal voltage sources?
how does a shunt reactor maintains the bus voltage???
What is the selection process of breakers. Can any one please give a formulation on same?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
What is an automatic controller?
What is the necessary condition for stability.
What was your role in the silicon evaluation/product ramp? What tools did you use?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
why we are using Load factor?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
