Why alternate bars are given bent-up in slab and how to
decide the length of bent up?
Answer Posted / muskan
The bent up is at L/7 distance
But in case the of a continuous slab, the bent up is at L/5.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain what is progress payment?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
a sewer which receives the discharge of no. of house sewer is called house sewer lateral sewer intrcepting sewer sub-main sewer
How to calculate the cement plastering for circular and rectangular water storage tanks and how to calculate the area of circular and rectangular floor?? Please help me
how to calculate the density for high density concrete ? or is it same as the density of RC?
What is factor not to be taken in consideration in mix design?
Why should you show Client/Engineer activities clearly on the project plan?
Will going from a 3-tap to 6-tap increase water pressure?
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
What is a tensile strength? What is the tensile strength of wood?
factory shed foundation l=4, b=3' d=8' rcc foudation for top to bottom pl tell me cement ,steel ,sand ,labour cost ,excavtion,soil is weak not so hard
how much deduction will be in 32 mm dia HYSD steel bar for 45 and 90 degree bend
if i used salt as a add mixture in concrete, then what will happen and what are the naturally available add mixtures.
225 mm thick RCC slab, how many ton load slab can carry? for example if 33 ton truck loaded with soil, truck having 6 wheels. slab can take load or not? grade of concrete is M35 and slab design Fe500, slab desing one way slab.
What are the main reasons for conducting pull-out tests for soil nails?