Interested to Buy Any Domain ? << Click Here >> for more details...
A current of 2A flows for 10 hour through a 100 ohm resistor. The energy consumed by the resistor is:(a) 0.5 kWh(b) 4 kWh(c) 2 kWh(d) 0.02 kWh
- 3 Answers
- 14013 Views
- I also Faced
- E-Mail Answers
Answer Posted / jashobanta kisan
Answer by Jashobanta
P= i2rt
P=2^2.100.10
=4000wh
=4kwh
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is the use of Surge Capacitor in LAVT?
how to handle 2500 kva transformar
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
what percent do you derate your copper wire when you change from copper buss to copper wire
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
what is the current setting for different relay protection for transformer .
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
what is the purpose of using filters in a protective relaying scheme?
Do inductive loads have distorted current waveforms ?
