how can a race around condition be eliminated using master
slave flipflop?????
Answer Posted / divya
A race around condition is arised when there is more toggle in flip flops so to avoid race around condition one works on positive master and slave active at negative when they holds that condition to not be changed until next state comes .
Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
why we change the direction of winding in rotor ?how we make the north and south pole?
How to Design green buildings services? What is the advantage to design green building?
how to calculate fuse rating for a motor
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
Hello sir i m student of gtu .what is idp.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
How to resolve if Diesel generator stop while running ?
what is the difference b/w pvc cu conductor and cu breaded wire..?