Interested to Buy Any Domain ? << Click Here >> for more details...
what is start up vent valve ? why it is used in boiler?
- 8 Answers
- 51754 Views
- ACC, Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / anandhan shanmugam
For starting time 25% valve open. After tg synchronisation the start-up vent close....
If any critical in boiler low temperature maintenance to open start up vent and increase the boiler outlet temperature.
Startup vent was- Airfail to close valve due to boiler safety purposes
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
How to calibrate Toxic gas detector?
How hart protocol can be connected with control valves?
How to fix back the valve actuator stem
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How the warning lamp of a charging-system is activated ?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
If fire would be inside the plant which fire detector is to detected the fire.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What are the uses of orifice plates?
Which topics are covered in Process Control?
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
What is zener diode? What is voltage regulator?
