Interested to Buy Any Domain ? << Click Here >> for more details...
if the transformer at full load have a iron loss =900w and copper loss = 1600w . what percent of the load will the transformer has a maximum efficiency?
- 3 Answers
- 16776 Views
- I also Faced
- E-Mail Answers
Answer Posted / hi2know
We know that at maximum efficiency in %= √Pi/Pc * 100 = √900/1600 * 100= 3/4 * 100= 75%
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
Advantage of LT panel vs HT panel
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why we are not giving the zone 1 trip command to the master trip relay
How the PF control while running DG set with load
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
why zero sequence impedance measurement is not applicable for single phase GT
What are all present producing cost of Per KWH of various Fuel?
Why is the frequency not changed during transformation of electrical energy in a transformer?
Mention how NPN and PNP transistor works?
how many joints are allowed in underground HT cable of 1 KM
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
What is The Resistance Formula
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
What is the equivalent circuit of a transformer and its vector diagram?
