Interested to Buy Any Domain ? << Click Here >> for more details...
We use MCCB not MCB for motor starters because MCCBs has capablity to drawout the motor starting current which is 5-6 times the full load current of motor for 1sec.
Then why we use SDF in starter panel means MCC panels.
Pls reply if any one knows this answer.
- 1 Answers
- 2654 Views
- I also Faced
- E-Mail Answers
Answer Posted / omer a.osman
What do you mean by SDF. I guess Star/Delta.
In this case, the starting current will be reduced & within 15 to 20 Sec. the Sytem will changed to Direct on line in running Condition by taking the full load current. Hence, the recommended MCCB rating as protective device to protect the feeders should not be less than the current carrying capacity & tripping current about 1.45In. However, the breaking Capacity of the MCCB is an essential factor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
what is meant by vector group of a transformer? How can it be derived?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
lamination figures
Why colled 440V to 3-phase supply.
What is Auto Mains Failure Panel & Auto Synchronizing Panel
What is the meaning of HT Trivector Meter ?
State thevenintheorem?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
why single CT used in DOL starter power circuit?
Can i use the B-curve MCB instead of C-curve MCB
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
