Interested to Buy Any Domain ? << Click Here >> for more details...
How To Measure Honey Comb Full Brick Work, Can we deduct Hole, If Yes, how to Calculate Rate Analysis
- 1 Answers
- 9124 Views
- HMM, Metec, I also Faced
- E-Mail Answers
Answer Posted / bulusu v s n murthy
Brick work per sq.m required bricks with wastage 54 nos (half brick wall) measurement for total area. No dediction of gaps .in honey comb b/ w nos required 44 nos per sample with wastage,now calculate rate per brick with nos add for scoffolding,highly skilled Mason,semi skilled Mason, in skilled workers as per our rata analysis in brick work only d quantam of work we get half of half d B/W quantity.supose 2 skilled+ 2 semi skilled+ 4un skilled can do 10 sq.m of half brick wall per day in case of honey comb it is 5sq.m.if u satisfy give feed back
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What happens when,in Prestressed girder the HDPE duct and cone size is provided more than required? (technical answer expected)
explain five benefits of using standard terminology in the measurement process?
WHAT WII BE THE WATER ABSORPTION POWER OF WOOD ?
what is right & short method of measurement of slab&beam
Floor to floor high of domestic building is 3m design a quarter turn staircase starting assume taken give a suitable diagram of it?
types of survey and levelling instrument ?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
in block masonry l=10',b=0.5',H=10',Calculate cement ,sand and no.Of blocks?
What is the FE 250 structural steel of 8mm tk plate testing sample intervals with IS code or international code?
what is the proper procedure in conducting a california bearing ratio penetration test on soil on cbr machine?
What is the difference between one-way slab and two-way slab?
What is alternate bid?
what is w/c ratio in dry lean concrete for m10 mix design
what is hydrostatic paradox?
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
