Answer Posted / narendra katakkar

First of all, a desired maintenance schedule is chalked out depending upon the diversity and intricacy of the installation. A typical maintenance schedule can be as follows.
1 Fix up a day (Maybe once a three months) and preferably when the installation is idle.
2 On that desired day the main power can be switched off, then disconnect all the neutral and body earth terminal connections.
3 Using Earth test instrument resistance of each earth station should be tabulated.
4 The earth stations to be properly watered or one can use drip irrigation system for continuous moisture retainment. If necessary add salt and charcoal or compound depending upon soil conditions. Excess of these materials to be avoided as this would lead to corrosion of earth electrode.
5 Check all the intermediate connections and remove rusted/corroded components.
6 Once again check the resistance values all the values should be below 2 ohms.
7 Connect back all the earth strips, on the power.
8 Fill up log book with noted resistance values.

What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?

1264

---

how can we say that stator magnetic field rotates with synchronous speed?can we derive?

1770

---

Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?

2007

---

What is FM200 Gas??Applications........

2365

---

What is stepper motor. What is its uses?

1262

---

advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor

1799

---

how many load we can take for lighting

2273

---

Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above

2214

---

How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.

1887

---

5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

3810

---

how to calculate units consumption for a 12 hp motor /hr.

1472

---

difference between a diode and thyristor?

2236

---

2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?

2013

---

What do you mean by screen of power cables?

1778

---

What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?

2978

---