Interested to Buy Any Domain ? << Click Here >> for more details...
why insulation cost is more in underground cable than in
overhead line?
- 2 Answers
- 3461 Views
- I also Faced
- E-Mail Answers
Answer Posted / sk.azhar.m
An underground line is fill in the earth and when if the leakage current will flo in the erth the current rating will very high in the cable that is very dangerous for human and other and in the the overhead line the air is not good conductor of electricity while an underground line is more insulation than overhead line for this reason the insulation cost is more in underground system
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is meant by impedance & transient protection?
why do we have spikes enough to burn electronic boards, when generators are not grounded
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
previous year paper of ntpc bhel for degree in electrical enng
how electrical earthing maintenance done in industry?
what is doubling factor in making current of a breaker?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What is big transformer parts and their function ? Ty
How the over load setting for HT Motors calculated-provided in Numerical Relay
what is the effect of back reactive power on the generator ?
What is the magnetic field (coil DC ) of Turbo Expander?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what is negative d.c. voltage, why this voltage is used in base transciever station.
