Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if we double the input frequency of a
transformer keeping the voltage constant?
- 6 Answers
- 24580 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh b.e
The same current will flow for both 50 and 100Hz frequency.The Only difference is hysteresis losses will be more if 100Hz given as input. .Which only used to test the transformer's for 60second to check insulation withstand capability. .Generally hysteresis losses will be there in transformers which depends upon core quality. .Magnetising and Demagnetizing of core for 100cycles leads to increase in hysteresis loss.That is losses in form of heat .Which gives raise to increase the oil temperature.Due to this effect , chemical reaction Will take place between copper and sulfur content in oil.finally formation of copper sulphate,which acts as a conductor and settled upon windings . circulating current Will be there due to mmf.which leads to heat and damages the windings dielectric strength.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is gridrotor resistance starter
ult of expression 'document.FrmQF.myem
what is ramping rate of generator
bsec exam syllabus (mis)
What is the function of the circuit breaker failure relay?
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
whit is 33kv power 300*300 cable full current with formula
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
BSNL TTA EXAM QUESTION
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
What is difference between start imitation and start interlock for 3 phase motor protection ?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
why use phase displacement in transformer.and effect of phase displacement on transformer
can any one tell in easy method for circulating current ??
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
