Interested to Buy Any Domain ? << Click Here >> for more details...
2. What are the parameters of EHT sub-station?
- 1 Answers
- 3530 Views
- APGenco, Blue Star, Enercon, I also Faced
- E-Mail Answers
Answer Posted / raj patel
parameters at EHT substation are voltage, current, power, load angle, frequency, active and reactive power flow.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is q factor?
why servomotor motor? where i apply for best output?
what is PID control in VFD drives?
how to build a network which step down 415v to 1v rms
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
List the power rating of any 5 important electrical appliances used in houses.
What is dynamo?How it works and what is the function of dynamo in a DG.
What is meant by bus bar protection?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
why we cannot protect 100% winding of an alternator by using differential protection?
How to improve fuel cell in a distribution system?
how many types of motor can be used in washing machine
