Interested to Buy Any Domain ? << Click Here >> for more details...
What is the different between buchholz relay and pressure
relief device?
- 2 Answers
- 19454 Views
- I also Faced
- E-Mail Answers
Answer Posted / rupesh birla
Baccho relay genral operated through gas actuated in transformer. And prv relay operated throw oil pressure in transformer.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
what is meant by flywheel and its role in retardation test
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
what is meant by neutral compensation factor and where it is used
What was your role in the silicon evaluation/product ramp? What tools did you use?
what is the use of vcb & isolator in substation?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
what is the relative size of single and three phase?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
how is the incoming cable size calculated for a given current rating of a panel??
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
What is the difference between PLC and Embeded system
