why is the vector group analysis done in transformer tests
- 28 Answers
- 66826 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / pratik patel
For parallel operation of transformer
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the main advantages of generalized error co-efficients?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
What OPGW is better than Microwave or PLCC???
What are the roles and responsibilities of electrical engineer in cement plant
How servo stabilizer works.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
Why mostly the HV side of transformer has Delta?
what is the purpose of shading ring or shading coil in electrical equipments.
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
what is the circutor?why we use it ?
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
Is it possible to connect a safety device in to parallel?
what is meant by motor startup supervision & motor load jam protection ?
