QUANTUM BIOLOGY - EXAMPLE 33.5 : (a) In the measurement of the number of photons received by a plant during photosynthesis, quantum meter is used. At 8 AM, 11 AM, 12 PM, 2 PM and 4 PM of the same day, the measured readings of the meter are 10, 70, 60, 120 and 120 units. Find the mode, median and min of the readings of the quantum meter. (b) Microtubule is used to carry information in a cell. If the cross-sectional area of the microtubule has a diameter of 25 nanometers, find the volume of the microtubule of 1 nanometer in height. State the assumption of calculation.
Answer Posted / kangchuentat
QUANTUM BIOLOGY - ANSWER 33.5 : (a) Mode = 120 (2 readings, greater than others with 1 reading). Median = 70 (since 70 is the middle, when the values are rearranged orderly as 10, 60, 70, 120, 120). Min = (sum of readings) / (number of readings) = (10 + 70 + 60 + 120 + 120) / 5 = 380 / 5 = 76. (b) Assumption : Microtubule is a cylinder. Let V = 3.142 x h x d x d / 4 where V = volume, d = diameter, h = height. Then V = 3.142 x h x d x d / 4 = 3.142 x n x 25 n x 25 n / 4 = 490.9375 n x n x n = 4.909375 x 10^2 x 10^(-9) x 10^(-9) x 10^(-9) = 4.909375 x 10^(-25) meters, where ^ is the symbol of power, n is nano or 10^(-9). The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why traction voltage is 25kv
What are the effects of oils on the properties of Polyolefins?
Can you pls tell me how to calculate the amphere rating of cable in case of three phase supply but all load is single phase
Explain the factors involved in considering the choice of dry screw compressor?
Why should a magnesium ribbon be cleaned before burning in air?
What are the types of load?
How to caliculate the boil up rate, dia and height in both packed and tray distillation columns and any referance books for the design.
What is the average salary for chemical engineers?
How can you estimate a gas flow based on two pressure measurements?
What step should be taken in process industries if the process variable is oscillating?
oil field interview question
What are some guidelines for designing for liquid and gas velocities in process plant piping?
What is some good advice for specifying allowable pressure drops in shell and tube exchangers for heavy hydrocarbons?
What are the three classes of organic solvents?
pleas tell me about chemical engineering apptitude test..