Answer Posted / nijagunayya hiremath
Dry lean concrete is the base for rigid pavements and is mixture of large ratio of 20 mm dn. Aggregate to cement usevally 14:1and cube strength shall be 5 N/ sq mm.
It has to be laid with paving equipment. It should be covered before putting above pavement layers by thin polythene sheet.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
relation bet Coefficient consolidation Cv, time factor Tv, drainage path d, & time t is Cv=d2Tv/t Cv=d2t/Tv Cv=tTv/d2 Cv=Tv/td2
Could you please give me an answer to the mixing proportion of concrete M1 grade (sterngth of 1 MPa)?
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
Define relative co-ordinates?
Explain what is Critical Path Method (C.P.M)?
How to make tiles floor step by step procedure?
What is the absolute pressure scale?
What is unit weight of normal concrete?
how many spacers we need for 1 ton reinforcement? aprox.
which is the cheapest type of flooring (say for using for 6 months in a factory building & dismantling it)?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
what is differences between ferrock and concrete ?
How Can I know the wastages(%) of each work added in estimating the quantity of construction materials?(Eg. Ceiling Work, Brick Work,etc....)
five benefits of using standard terminology in the measurement process
Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.
