IF 5000amp current on LT 440V. then how much it will draw
amp on HT 11KV side
- 10 Answers
- 24967 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
HT side 22amps LT side 22*25 550amps
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to findout raw or ups power? its not indicated in socket,
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
how to ctrl motor by use of ac or dc drive.plz explain evdintly
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
why generator efficiency is more in swinburnes test?
what is active power & reactive power?
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
how does WTI work ?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
why the check zone and main zone are used for Busbar Protn. scheem?
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
