For testing 33kv cable hipot testing. How much kv we have to
Apply .Give in details.
Answer Posted / martin thomas
Iec code
Ac= (2 x e) 1
Dc={(2 x e) 1} x 1.414
1.414=sqrt (2)
E= rated voltage
Aramco std
Dc =4 x u
U= phase voltage
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the vector group of a transformer,how can it be found out?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is meant by rotor?
Tell me in detail about c.t. And p.t. ?
How we calculate the current carrying capacity of H.T. cabel?
what will happen if ac and dc supplies given
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
What is Annunciation?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
how to check regenerative load in drived motor
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
what is the practical application of full adder circuit?
How would you relate your key competencies to this position?
What does the term power factor shows?
Transformer diagram mention each parts ?