Interested to Buy Any Domain ? << Click Here >> for more details...
NATURAL GAS ENGINEERING - QUESTION 26.1 : (a) In natural gas pipe sizing, the length of the pipe from the gas source metre to the farthest appliances is 60 feet. The maximum capacities for typical metallic pipes of 60 feet in length are : 66 cubic feet per hour for pipe size of 0.5 inches; 138 cubic feet per hour for pipe size of 0.75 inches; 260 cubic feet per hour for pipe size of 1 inch. By using the longest run method : (i) Find the best pipe size needed for the capacity of 75 cubic feet per hour. (ii) Estimate the suitable range of capacities for the pipe size of 1 inch. (b) The maximum capacities for typical metallic pipes of 50 feet in length are : 73 cubic feet per hour for pipe size of 0.5 inches; 151 cubic feet per hour for pipe size of 0.75 inches; 285 cubic feet per hour for pipe size of 1 inch. By using the branch method find the best pipe size needed for the capacity of 75 cubic feet per hour when the length of the pipe from the gas source metre to the appliance is 52 feet.
- 2 Answers
- 2512 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
NATURAL GAS ENGINEERING - ANSWER 26.1 : (a)(i) Best pipe size needed = 0.75 inches for the capacity of 75 cubic feet per hour. Data for a metallic pipe of 60 feet in length and maximum capacity of 138 cubic feet per hour instead of 66 cubic feet per hour are selected. (ii) Range is more than 138 but less than or equal to 260 cubic feet per hour for pipe size of 1 inch. (b) Best pipe size needed = 0.75 inches for the capacity of 75 cubic feet per hour. Data for a metallic pipe of 60 feet in length instead of 50 feet and maximum capacity of 138 cubic feet per hour instead of 66 cubic feet per hour are selected. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is cathodic protection, how it works in Turbine condensers ?
hi all i have doe cheical engg, but i have to go for iob po interview so can anybody suggest me abt the kind of qns that can be asked.
can anybody give me syallbus of chemical engineering for section engineer in railway.
how does refractive index detector work?
What is a cstr and what are its basic assumptions?
Explain what type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
What are advantages using hollow shaft impeller?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
What does the catalytic converter on an automobile really do?
Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?
Why are decomposition reactions called the opposite of combination reactions?
Explain the different characteristics that can affect the flow of bulk solids and how?
What are the advantages of using a ball mill over other conventional methods of crushing?
Define a barometric condenser?
How can separation of chiral chemicals affect the chemical and/or pharmaceutical industries?
