Interested to Buy Any Domain ? << Click Here >> for more details...
1.two coupled coils with L1=L2=0.6 H have a coupling
coefficient of k=0.8 the turns ratio N1/N2 is......
- 5 Answers
- 32282 Views
- BSNL, SSC, I also Faced
- E-Mail Answers
Answer Posted / achintya kumar shit
We know that, Inductance L=(N*phai)/l
So, L1/L2=N1/N2
or, 0.6/0.6=N1/N2
or, N1/N2=1
| Is This Answer Correct ? | 33 Yes | 4 No |
Post New Answer View All Answers
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
how to define tell me about self
how to design the heater in temperature control unit to heat 50KL of water?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
how r charge carriers produced
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
Explain thin film resistors and wire-wound resistors
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
What type of pipe material G.I or M.S is used for sprinkler system?
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
