what is the input of ph sensor and meter during the
calibration time and what is the output?
Answer Posted / amy
7 pH is a input and 0 mV output during calibration of pH meter.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is shielding effect?
what diffrence b/w plc s7200,300,400
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
use of split range ? where it is used ? in which control loop it is used ?
how to design orifice plate?what is the equation?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
Reason for capillary type dp level transmitter fluctuation
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
What is force balance principle?