what is the full form of XLPE adn there use.
Answer Posted / mitesh jadhav
Cross linked polyethylene insulated power cable (XLPE cable)
X - Cross
L - Linked
PE - Polyethylene
Is This Answer Correct ? | 28 Yes | 0 No |
Post New Answer View All Answers
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
What happens when ac supply is given as excitation voltage instead of dc supply
HOW TO CALCULATE S/C,O/C,E/F OF ACB.
Earth bits close or open. Which is correct
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
what do w do when the output of generator is fluctuating?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
How we can calculate the life of Lead acid battery
Why reactors use before incoming of ac vvfd drive?
what is a vector protection in transformer
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
how to calculate compresor capacity?