Interested to Buy Any Domain ? << Click Here >> for more details...
What are the conditions to be satisfied before connecting
two DC generators in parallel?
- 9 Answers
- 17549 Views
- Bhel, Godrej, I also Faced
- E-Mail Answers
Answer Posted / lucky
The following conditions must be satisfied for the paralleling of DC generators:
a. The polarities of the generators must be identical.
b. The terminal voltages must be the same.
c. The change of voltage with the change of load must be the same character.
d. The prime movers driving the armature of the generators must have similar and stable rotational characteristics.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
How much dc volt applied in cathodic protection system?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what is the need of starter in tube light and what type of starter is used in that?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
Difference between Earthing Truck & Earthing trolly for HT panel
state the disadvantages of carbon filament???
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
I need HT sphere gap calibration table. Can any body help me.
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
HI SIR, AM PREPARING FOR RRB FOR SECTION ENGINEER POST. PLZ SEND ME THE PREVIOUS QUESTION PAPERS AND HELP ME. I HAVE NO ENOUGH TIME MY EXAM DATE IS 22ND JUNE.... MY EMAIL ID IS nalla.amarnath@gmail.com
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
