what will happen when a bulb s connected btwn two phases of
a three phase delta connected source?
Answer Posted / tstar
If it is like delta connected for line to line and no neutral then, one side of delta connected bulb will glow brighter,the other two sides will go dimmer, probably one side of it won't glow.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
How we select the vector group of 3phase power transformer?
what is conductor copnstant of ab cable
how to compute kvar in substation feeder to improve power factor and sending voltage
What are the major reasons for balancing hydro-thermal mix?
mccb service sittings be done?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
what r the checklist while installing a 380 kva DG set
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.