Hi friends.
is it possible that SCADA System through RTUs can connect Via PLCC Communication carriers ?
thanks
- 1 Answers
- 1738 Views
- I also Faced
- E-Mail Answers
Answer Posted / asmoorthi2000@gmail.com
Yes possible to connect the RTU through the Power line carrier communication(PLCC). The speed level is 1.2kbits to max 9600 kbits.
The drawback of the PLCC is due to corona effect or a heavy fog in the surrounding the line will disturb the communication.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
What is installed in PAC that is control the humidity
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
What is the application of Dyn1 and Dyn11 vector group of transformer?
how slip power recovery system work
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
what is parellel power factor correction?
What is reverse power relay?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
How can you sized or estimate the ligthning arrester current rating?
