Interested to Buy Any Domain ? << Click Here >> for more details...
we want to feed 3 phase supply to 70 ton AC load.what will be the size of (3 phase)cable require.
- 2 Answers
- 6231 Views
- BSES, I also Faced
- E-Mail Answers
Answer Posted / faizan
For cable selection we need supply voltage,load current and distence between source to load end ,then we can choose the size of cable and also it depends on meterial of cable,( cu/alu )..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
thyristor controlled APFC panel design parameter?
sir& friends i want the collection of recent quetions asked in interview of top most companies please send me on my email san.jsr@hotmail.com
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
Swg formulae
what r the checklist while installing 500 kva transformer
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
what is meant by class 1 E in electrical power supply?
What is the limitation of kirchoffs law?
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
what is sevice settings for mccb?How can be it setted?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
can we use engine degreaser for electrical motors?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
how can we calculate the ratio of caustic soda and water in lrs.
