Interested to Buy Any Domain ? << Click Here >> for more details...
Question 102 - (a) As an approximation, let v = Zc / 137 where v is the radial velocity for 1 s electron of an element, c is the speed of light, Z is the atomic number. For gold with Z = 79, find the radial velocity of its 1 s electron, in term of c and percentage of the speed of light. (b) As an approximation, let A x A = 1 - Z x Z / 18769 where A is the ratio of the relativistic and non-relativistic Bohr radius. Find the value of A.
- 1 Answers
- 2899 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
Answer 102 - (a) Approximately v = Zc / 137 = (79 / 137) c = 0.5766 c or 57.66 % of the speed of light. (b) Approximately A x A = 1 - Z x Z / 18769 = 1 - 79 x 79 / 18769 = 0.667 then A = 0.817. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the some common causes of control valve noise?
Jspl question paper for freshers requirements chemical engineering diploma
Are you having any experience in antibody designing?
Where the Induced draft, forced draft & balanced draft furnace are to be used? Selection of furnaces are based on which criteria?
Explain some good strategies for curing tube vibration in shell and tube exchangers?
why screw compressor use for ammonia compression?
i need last year question paper of GATE exam of chemical stream.but i failed i geting exam papers.soits humble request to u that if any body found last years GATE exam paper of chemical stream then send it to on this mail address.i shall be thankful to u for this. mail address:- sachin_4255@yahoo.co.in thank you.
What is a solvent?
Define a solvent?
What is the ignititon temprecher of Diesel,Petrol&Carosion oil.
Why should a magnesium ribbon be cleaned before burning in air?
What is a good source of information for the design of pressure vessels?
hi all i have doe cheical engg, but i have to go for iob po interview so can anybody suggest me abt the kind of qns that can be asked.
What is a good way to get started in doing a plant-wide steam consumption analysis?
For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?
