Interested to Buy Any Domain ? << Click Here >> for more details...
What are the steps taken in troubleshooting of a machine
e.g extruder
- 1 Answers
- 2985 Views
- L&T, MAHINDRA, ME, I also Faced
- E-Mail Answers
Answer Posted / s
Verify that a problem actually exists.
Isolate the cause of the problem.
Correct the cause of the problem.
Verify that the problem has been corrected.
Follow up to prevent future problems.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can hyrogen be used as fuel in parral with coal in boliers
Explain the formula of heat loss in a pipe.
I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?
plz give sample question paper of hpcl thank you shinde_murali@yahoo.co.in
What is the formula for 1 HP of a two-cycle engine?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
Why pert is preferred over cpm for evaluation of project ?
What causes a hydraulic cylinder to skip?
pleas send me the syllabus of rrb je examination(mechanical)
What is the difference between shear center flexural center of twist and elastic center?
whats the Formula to calculate temperature of steam at given pressure
What is conduction?
What is a bearing? What are the different types of bearings?
Define grashof number [gr].
WHAT ARE EARTH MOVING M/CS? WHAT IS BATCHING PLANT? WHAT IS HYDRAULIC JUMP? WHAT IS TIPPER (EARTH MOVING M/C)?
