Interested to Buy Any Domain ? << Click Here >> for more details...
Dear Sir/Madam,
I am attending an interview for ETs in BHEL. I have cleared
my written test under Electronics (Instrumentation). This
is the first time I am appearing for an interview. Can any
one who has attended the interview earlier give me a clue
to face the interview.
With regards
Sindhu
- 2 Answers
- 6320 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / ramesh
http://instrumentationinterview.blogspot.com/
hi go through the above blog.maximum instrumentation question answer you can find there.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
key exchanges in wpa,wpa2,tls
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
Manipulation of dead wt. tester double piston type.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
What are different types of orifice plates?
if my flow is 20000 m3/h than which range of DPT i have to use????
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is the input to be given in digital flow meter during the the calibration time?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
