I have a problem with a valve (air to close).
When it is fully closed and try to open 1% it doesn't responce till 3% open suddenly more than 3% then back to 3%.
I tried to tune positioner then removed it, the problem still exist.
Any idea
- 3 Answers
- 2642 Views
- I also Faced
- E-Mail Answers
Answer Posted / smith
which type of positioner you are using?. it depends on the positioner. try to tune it correct manner you will get the output.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what can of fault ofently come in vibration mesurement?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
can you send remote seal interface level transmitter calculation steps for oil water saperator.
what would be the minimum flow rate that we can measure on rotameter..?
what are the selections available in configuring a burnout protection of a controller? thanks
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is profibus?
What is solenoid valve? Where it is used?
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
Difference between ultra sonic flow meter
Linear amplifier.
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How to convert milliampares into flow??
