Interested to Buy Any Domain ? << Click Here >> for more details...
Question 95 - The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.
- 1 Answers
- 2251 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
Answer 95 - Let (f-factor) = (analyte signal) (concentration of internal standard) / [ (internal standard signal) (concentration of analyte) ]. For first solution, (f-factor) = (2 mamps) (4 mM) / [ (3 mamps) (3 mM) ] = 8 / 9. For second solution, (f-factor) = (1 mamps) (1 mM) / [ (4 mamps) (2 mM) ] = 1 / 8. Average : Average f-factor = (8 / 9 + 1 / 8) / 2 = (64 + 9) / (72 x 2) = 73 / 144. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Types of column foundation and how to calculate its steel quantity.
how many types of sensors used in a air handling unit
What is the condition to be satisfied in the selection of l and c in a series inverter?
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
Mention any four accessories used in pre historic period.
What are the various types of rotor used in the alternators?
What is silk dyeing?
What is ionospheric bending?
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
What are the basis on which the best material for sliding contact bearings manufacturing?
Define fan-in and fan-out?
Discuss about the costumes of Gupta period.
What do you understand by catenary cable ?
Why DG Set manufacturers do not give options for alternative fuels. They even do not allow to change at the cost of custmers.
State some precautions to be taken in case of powder metallurgy?
