Interested to Buy Any Domain ? << Click Here >> for more details...
I've one slab of 24m x 43m. How to calculate required steel
For this slab.
- 5 Answers
- 12714 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / saravanan
hi.
1) length of slab/spacing=no of bar lager side
2) width of slab/spacing=no of bars in shorter side
3) length of one bar = length of slab-(2*cover thickens)
4) length of one bar longer side*total no of bars in longer side(+)length of one bar shorter side*total no of bars=total length of bars requirement in slab
..weight of one meter bar =d^2/162
total weight of bars=total length of bar*weight of bar
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the disadvantages while using stone dust as filler in pavements?
what is the tensile strength of 10swg and 8swg gabion wire?
1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
As we know that steel is a tension member but why we are using STRUCTURE STEEL as a COLUMN (Without concrete) where column is a compression member and compression strength of steel is very low
if the nitrates more than 45mg/l in water lead to disease then what is it called
What is the meaning of Brick- M 35 grade? Is it a common brick or it's a concrete brick?
B.M DIAGRAMS & S.F DIAGRAMS OF CONTINOUS BEAMS
how to calculate the size of triangular ring in rcc column?
Will going from a 3-tap to 6-tap increase water pressure?
How can i do RCC rate analysis?
List out the potential risk factors for workers on the construction site?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
quantity of material needed for rubble stone masonry for 1:4 and 1:6
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
