Interested to Buy Any Domain ? << Click Here >> for more details...
What is use of 3phase instead of single phase?
- 12 Answers
- 16978 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / abhishek roy
In industries there are large machines are used which is only depend on 3-ø supply.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is resver in electrical enginnering with answer
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
What is the real function of reverse power relay in generator panel while syncronising?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
What is servo motor? what is its purpose?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how oti and wti connections are different from each other?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
Why is negative feedback invariably preferred in closed loop system?
what is allowable ac mixing in dc
