Interested to Buy Any Domain ? << Click Here >> for more details...
PROCESS CONTROL - EXAMPLE 6.2 : A stream with volumetric flow rate Q enters a cylindrical tank and a stream with volumetric flow rate q exits the tank. The fluid has a constant heat capacity and density. There is no temperature change or chemical reaction occurring in the tank. Develop a model for determining the height of the tank, h. Let V is the volume, A is the cross sectional area, r is the density, m is the mass, where V and A are for the tank, r and m are for the fluid. The rate of mass of fluid accumulation, dm / dt = (Q - q) r. Prove the model to be dh / dt = (Q - q) / A.
- 1 Answers
- 2332 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
PROCESS CONTROL - ANSWER 6.2 : Mass of fluid in tank, m = Vr = hAr. Then d (hAr) / dt = (Q - q) r. Ar (dh / dt) = (Q - q) r leads to the answer A (dh / dt) = Q - q. Finally dh / dt = (Q - q) / A. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much water is lost through a commercial cooling tower system with a throughput of about 600 gpm?
What is the Import Procurement Cycle ? and what are the customization steps in SAP ?
Define octane number?
Explain what are flameless oxidizers?
In Pressure Sfety Valve(PSV) 2" by pass line why given for process units.
What chemical is used to expand air bags in such a short amount of time?
What does the catalytic converter on an automobile do?
Explain why does catalytic converter used in an automobile?
can you explain about the design calculations and procedure of boiler
What is a good source of information for the design of pressure vessels?
What are some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?
what is the difference between car seal close/open valves and lock close/open valves?
When using a pumping loop to mix two miscible fluids in a tank, when can the content are considered well mixed?
How to size the cooling tower sump / basin for any given circulation rate? What is the guideline?
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
